Sonic Inspector

We are currently seeking a Sonic Inspector in the Billet Inspection department at our Monroe, NC facility. As a sonic operator, you will play a valuable role in helping ensure our products and materials meet customer expectations. As a sonic operator, you will be responsible for processing material in the sonic tank and through the immersion tactic to perform contact sonic. A successful candidate should demonstrate an eagerness to learn, showing initiative, commitment to teamwork, attention to detail, integrity, and honesty. This is a night shift position from 6:00 pm to 6:00 am, working on a rotating 2-2-3 schedule. You will work 2 days, have 2 days off, work 3 days; then 2 days off, work 2 days, then have 3 days off. **Additional Responsibilities:** - Perform tasks to assist in set-up and operating equipment - Follow prescribed safety regulations - Maintain accurate, complete, and legible logs, records, and charts - Operate heavy machinery such as forklifts and cranes - Train for 3 months (or 400 hours) and receive 40 hours of classroom training and receive hands on instruction - Learn to operate all instruments and test systems - Learn to read technical instructions and mill instructions - Written and practical examinations will be administrated after 3 months training - Upon receiving passing results, will reach level I after completing 400 hours of training **Level I:** - Continue training in the above tasks - Must be able to make specific calibrations of all test systems according to procedures - Must be able to verify that equipment is calibrated - Will be able to operate the equipment under the direct supervision of a Level II - Will receive 40 hours of classroom training to perform all techniques necessary to become a Level II inspector including immersion testing (nuclear and non-nuclear) and contact testing (nuclear and non-nuclear) - After 12 months (or 1600 hours), no more than 14 months experience since the beginning of training, and 40 hours of classroom training, a written practical examination will be administered - Failure to pass the examination on the third attempt will disqualify that person to be Level II and will require assignment to another job if available and qualified **Level II:** - Will be able to operate all equipment and systems, in all techniques (immersion, contact, longitudinal, shear wave, nuclear and non-nuclear). - Will be able to accept or reject indications, perform calibrations, and work to all procedures as required - Should be able to organize and report inspection results in a thorough manner - Must be thoroughly familiar with the scope and limitations of the techniques for which the individual is qualified and must be able to apply those techniques as required - Requalification will be every 3 years by written and practical examination as required by T.I. QC-20 addenda 1 and 2 - Failure to requalify on 3rd attempt will result in the same actions as above. - An employee must work in the position for a minimum of 2 years to be eligible for job posting. **We thrive when the expectations are great, and the barriers are high. We're solving the world's most difficult challenges through materials science.** Our advanced, integrated process technologies and proven performers give us a tremendous competitive advantage. When customers systems need to fly higher, dig deeper, stand stronger, and last longer -- anywhere on, above or below the earth -- ATI is proven to perform. \*It is ATI's policy to not provide immigration sponsorship for any of the company's positions. **Preferred Qualifications** - One (1) year of manufacturing experience is preferred **Skills** - Basic math skills, including addition, subtraction, multiplication, and division in all units of measure including whole numbers, fractions, and decimals - Basic computer skills - Ability to read tape measure and micrometer - Ability to read and understand instructions - Ability to utilize common hand tools - Ability to lift object…