Installation Technician

## Description **Mechanically support the installation of material handling systems. This includes but is not limited to assembling and securing the equipment.** ## Requirements Duties & Responsibilities · Meets acceptable attendance, time/work standards · Keep accurate and complete expense reports on a weekly basis · Drill holes in concrete floor, install anchors and secure equipment · Route and fasten conveyor belts through roller conveyor with little instruction · Able to remove and set conveyor rollers · Keep work area clean and organized · Follow all workplace rules and safety guidelines · Follow written and verbal instructions from the Crew Lead or Level A Installer · Perform other duties as assigned · Conveyor knowledge progression (able to identify different equipment) · Unstack and place conveyor to zero line · Square conveyor · Install air lines based on drawings · Understand functions of a solenoid (in and out ports) · Able to identify general electrical and mechanical parts · Proficient in shop math · Obtain fork truck license · Understanding of basic electrical theory · Able to use hot stick to determine voltage presence · Able to use voltmeter to measure voltage and OHMS (continuity) with guidance if needed · Able to run conduit and operate tube bender (basic bends: 90’s, offsets, 3-point saddles) · Able to make wire pulls and connections as well as install general electrical components (solenoids, photo-eyes, ect.) · Able to layout and install basic infeed’s and dischargers per drawings Education & Experience · High school diploma or GED Technical Skills/Working Knowledge · Able to read a tape measure accurately to the 1/16th of an inch · Able to identify and use basic mechanical hand tools o Standard and metric open end and box wrenches o Adjustable wrench/adjustable pliers o Ratchet and sockets o Sledgehammer o Speed square/framing square o Tubing cutter · Able to identify and use basic electrical hand tools: o Phillips and flat head screw drivers o Termination/control screwdriver o Side cutters/dykes o Wire strippers Able to identify and use basic power tools: o Portable band saw o SDS rotary hammer drill o Reciprocating saw/ saws all · Basic understanding of electrical drawings · Basic understanding of 3-phase circuits · Basic understanding of control circuits · Working knowledge of pneumatic systems, including installation, start up and mechanical troubleshooting Work Environment · Ability to work in a fast-paced environment with changing priorities · Must be able to work the mandatory hours and weekends as required · Ability to travel on a frequent basis to project sites within the US. · Must be able to perform repetitive bending, lifting, working on knees and floor **· Must be able to lift a minimum of 50lbs**