Avionics Production Engineer (II or III)

Space is a warfighting domain. True Anomaly seeks those with the talent and ambition to build the technology that secures it. OUR MISSION True Anomaly delivers decisive capabilities for space superiority. We build autonomous spacecraft, advanced payloads, mission software, and space-based interceptors — enabling the U.S. and its Allies to secure the space environment and counter threats from the ultimate high ground. OUR VALUES Be the offset. We create asymmetric advantages with creativity and ingenuity. What would it take? We challenge assumptions to deliver ambitious results. It’s the people. Our team is our competitive advantage and we are better together. YOUR MISSION We are revolutionizing spacecraft systems and are looking for a candidate with a passion for being hands-on and helping build new technologies . Our production engineers do what it takes to ensure production can keep building. You will gain experience at every phase of the spacecraft program including design, analysis, manufacturing, test, and flight. The company culture is one of innovation and speed, so if you are looking for a place that allows you to reach your full potential, this is the job to consider. RESPONSIBILITIES Generate work instructions for mechanical and electrical assemblies Supporting production operations as needed to ensure workflow stays uninterrupted. Generate NCR’s (non-compliance reports), support investigation through resolution, and own the execution of dispositions. Manage calibration and certification of mechanical and electrical GSE (ground support equipment). Provide technical and engineering assistance to team of technicians. Complete process improvements and corrective actions to increase efficiency of production. Provide manufacturing expertise to design engineering and contribute to documentation such as drawings, SOPs (standard operating procedures), etc. Create spacecraft assembly kits for rapid production. QUALIFICATIONS Bachelor's degree in manufacturing, industrial, mechanical, electrical engineering or related field 2-4 years of experience for a level II or 4+ years of experience for a level III Experience with PLM, MES, configuration and data management controls and systems. Experience working to AS9100 process and standards. Experience with working hands-on-hardware and fabrication methods Experience building and producing classified hardware in SCIF’s or SAP facilities. PREFERRED SKILLS AND EXPERIENCE Experience building space hardware including, but not limited to, fluid systems, structures, harnessing, or PCBAs COMPENSATION Base Salary: Level 2: $75,000 - $120,000 Level 3: $90,000-$155,000 Equity + Benefits including Health, Dental, Vision, HRA/HSA options, PTO and paid holidays, 401K, Parental Leave Your actual level and base salary will be determined on a case-by-case basis and may vary based on the following considerations: job-related knowledge and skills, education, location, and experience. ADDITIONAL REQUIREMENTS Clearance — Ability to maintain or obtain TS/SCI clearance. Work Location — this a fully onsite position based out of our Centennial, CO office. Work environment —the work environment; temperature, noise level, inside or outside, or other factors that will affect the person's working conditions while performing the job. Physical demands —the physical demands of the job, including bending, sitting, lifting and driving. This position will be open until it is successfully filled. To submit your application, please follow the directions below. #LI-Onsite To conform to U.S. Government space technology export regulations, including the International Traffic in Arms Regulations (ITAR) you must be a U.S. citizen, lawful permanent resident of the U.S., protected individual as defined by 8 U.S.C. 1324b(a)(3), or eligible to obtain the required authorizations from the U.S. Department of State. True Anomaly is committed to equal employment opportunity on any basis protected by applicable state and federal law…